KUHN RIKON Corp. Drill 30-100 User Manual download pdf (Page 8)

Assembly

3. Slide the drill press head over the column.

(Fig.03)

4. Center the drill press head over the table and

base. Tighten the drill press head into position

by locking the two hex screws on the side of

the casting. (A-Fig.04)

Fig.03

Fig.04

5. Next, slide the 1/2” chuck (A-Fig.05) over the

pre-installed spindle (B-Fig.05). Open the

chuck jaws fully and tap into place using a

rubber mallet or a hammer and block of wood.

Fig.05

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

No comments

KUHN RIKON Corp. Drill 30-100 User Manual Page 8