3
5073TR 005907 R060706
Kuhn Knight, Inc.
1501 West 7th Ave., Brodhead, WI 53520
701 Cherry Ave., Greeley, CO 80632
Figure A
Using This Service Parts Listing
This listing uses a number indentation system to
specify the parts of an assembly. Any number which
is indented to the right, indicates that it is a compo-
nent of the item to the upper left. Example:
Part no Qty Description
102-AAA # Assembly A
102-BBB # Sub-Assembly B
(Component of A)
140-xxx # Sub-Component of B
140-xxx # Sub-Component of B
102-CCC # Sub-Assembly C
(Component of A)
etc.
Using this system, the subassemblies and their
components are included if an Assembly is ordered.
Similarly, the components of a subassemblies are
included if a subassembly is ordered.
The quantity (Qty) associated with an assembly,
represents the number of times an assembly could
be shown in the drawing. The subassembly quantity
however, is the number of times a subassembly is
used to build one assembly. Similarly, the compo-
nent quantity refers to the number of times a given
component is found in one subassembly.
MODEL AND SERIAL NUMBER INFORMATION is
located near the front left hand corner (Fig. A). The
model number, serial number and part number
should be known when asking service personnel for
parts.
The serial number may consist of a number, or a
number with a letter prefix. When referring to serial
number breaks in the text of this manual, a serial
number with a prefix will have been manufactured
after a serial number without a prefix (A001 made
after 0123). Likewise, a higher prefix letter would
indicate manufacture after a lower prefix letter (B001
made after A123). Therefore, if the text refers to
units manufactured after serial number B123, this
would include “B” series numbers greater than 123,
and all numbers with a higher letter prefix.
If you cannot find the part you need, be as descrip-
tive as possible when placing an order:
Sprockets: give the bore size, number of teeth, and
size of keyway.
Roller chain: give the size of chain (stamped on the
side of each link) and number of links.
Shafting: give the diameter, length, and quantity
and size of keyways.
Hardware is generally not included with parts. If you
need any hardware, check the size, the length, and
the grade (Fig. B), then check the hardware list in
this manual for the part numbers.
All hex head bolts are grade 5, and nuts are
grade 5 unless otherwise stated.
The hardware listing also includes zerks, cotter pins,
set screws, and roller chain links.
The illustrations in this manual are meant to be used
only as a guide for identifying parts and locating their
relative positions.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals